![]() The contour is drawn with a preconfigured tool. After completing the setup, click click en Accept . In the settings window, you can select the fill type (color or pattern), blending mode, opacity, adjust the fading.To fill the resulting outline, right-click on the canvas and select the element "Fill the outline" .The closure of the route occurs when we click (put a point) on the starting point.CTRL pressed, the movement of the rays - with the key OTHER pressed. The movement of any point on the contour is carried out with the key.The beam should disappear completely.īending the outline can be done in another way: put two points (without bending), then put another between them, hold down the key CTRL and pull in the desired direction. To avoid bending the next section, you must hold down the ALT key and use the mouse to return the beam to the point from which it was extended. To (before setting the point) find out how the contour will be bent, you need to check the checkbox "Watch" in the upper configuration panel. If the beam is not touched and the next point is placed, the bend will automatically bend. ![]() The direction of "pull" depends on which side the section will bend between the points. We put the second point and, without releasing the mouse button, we stretch the beam.Place the first anchor point with the pen.The guides (we'll call them rays) allow you to fold the area between the two previous points. Toolpaths are made up of anchor points and guides.
0 Comments
Leave a Reply. |